How To Keep A Flame Genie Burning
Flame Genie. Company was formed in 1947 and builds a variety of products related to residential heat generation and ventilation Flame Genie currently offers one fire pit in 4 configurations, the Inferno (in stainless or black; 13.5" or 19") How do you light wood pellets? Fill the stove's hopper with wood pellets. Open the burn pot door and add accelerant to the wood pellets. Hold a long-reach butane lighter, like those used to light gas fireplaces or grills, near the pellets and light it. Wait for all the pellets to be fully ignited; they turn red around the edges when burning.
Regular high-temperature spray paint will work, but baking in a large oven allows the coating to adhere properly. Lastly, powder coat is a less common finish but is seen on budget options like the Flame Genie. While powder coating is a great option for many applications, it is not the best for repeated high-heat usage, like in a fire pit. Keep the Flame Genie running for about two hours (maximum) with only half a bag of pellets (estimated). Therefore, you will need comparatively less fuel to run this fire pit, and you can also conserve fuel resources. Compared to the cost of quality firewood, the wood pellets are way cheaper. So, you can save a bit of money with the Flame Genie.
To start a fire, you fill the thing to the depth indicated by a few cutouts on the inside of the pit. This is a depth of about 2" of pellets. Get your fire going and within maybe 10-15 minutes it'll get hot enough to start the secondary burn around the top ring of vent holes. This fire will be very hot and amazing in appearance. Nearly zero smoke. The Flame Genie has a mesh bottom grate that allows air to flow through aiding in pellet combustion. The air then flows into the heating chamber feeding the burn. When you are done enjoying your Flame Genie Pellet Fire Pit, just let the fire go out. Click to see full answer Thereof, can you cook on a flame genie?
Flame Genie should be placed on a non-combustible surface, such as a patio block, which will also act as a catch for the small amount of ash generated by the Flame Genie. Load the Flame Genie with approximately 2 — 2 1/2" of wood pellets before lighting. Fat Wood works well to start your Flame Genie. Once you have your Flame Genie ready to go all you have to do is fill it with pellets and light it. To load your fire pit fill the drum with approximately 2 ½ inches of wood pellets. After adding the pellets I like to use a fire starter to get the fire going. Just light the fire starter and place it on top of the pellets.
Regular high-temperature spray paint will work, but baking in a large oven allows the coating to adhere properly. Lastly, powder coat is a less common finish but is seen on budget options like the Flame Genie. While powder coating is a great option for many applications, it is not the best for repeated high-heat usage, like in a fire pit.. Keep the Flame Genie running for about two hours (maximum) with only half a bag of pellets (estimated). Therefore, you will need comparatively less fuel to run this fire pit, and you can also conserve fuel resources. Compared to the cost of quality firewood, the wood pellets are way cheaper. So, you can save a bit of money with the Flame Genie.